DREWNOCHRON VARNISH 2in1 DARK ROSEWOOD 2.5L

Varnish Stain 2in1 is intended for the decorative and protective painting of wooden and wood-based objects indoors and outdoors. Transparent stain gives an elegant satin finish, highlighting the natural grain of the wood. Exterior: soffits, fences, garden furniture, wooden doors and windows, wooden facades,
gazebos, summer houses. Indoors: doors, windows, panelling. 

MAIN PRODUCT ADVANTAGES

- 2in1 - protects and decorates
- Easy to apply - does not drip
-Resistant to UV rays
-Resistant to changing weather conditions
- Emphasises the natural grain of the wood
-Interior and exterior
- Resistant to mould and algae -Mould and algae resistant
-Up to 6 years surface protection
* for vertical surfaces, depending on the conditions of use

TECHNICAL DATA

Degree of gloss: Satin

Spreading rate: up to 14 m2 / l, per coat depending on surface absorption and roughness

Thinner: Water

Application methods: PremiumMix brush, FELT roller

Drying time: Surface drying time 4 h. Application of the next layer after 2 h. Recommended number of coats: 2.

APPLICATION INSTRUCTIONS
Application conditions
The air temperature during painting and seasoning should be between +5°C and +25°C. The optimum temperature of the substrate
during painting should be between +15 and +25 ºC. The humidity of the wood should not exceed 11 % indoors and 15 % outdoors.
Surface preparation
Level, sand, de-dust and degrease the substrate. Remove flaking from previously painted surfaces, sand down and remove dust.

The surface should be clean and dry. Protect objects used outdoors (previously unpainted) with
wood preservative primer. Indoors, prime bare wood with Varnish Stain 2in1 with 20 % water.
Stir the varnish thoroughly before use. Apply 2 coats indoors. Outdoors apply
Outdoors apply min. Outdoors apply at least 2 coats. Allow an interval of 2 hours between coats. Full drying of the coating is achieved after 4 hours.
Low temperatures and high humidity prolong the drying time. For a better decorative effect, sand the previous coat with a
sand with fine sandpaper grit 180-220 after min. 4 hours drying time and remove dust. Paint in accordance with
The best results are achieved when using a paint spray. For best results use mixed bristle brushes (Pes-Mix). Do not
paint in humid conditions (e.g. during or when there is a likelihood of rain, fog, snow), in the afternoon and in strong wind.
in strong wind.
Recommended thinner: water.
Attention
During and after painting, ventilate the rooms before use until the characteristic odour disappears.
odour disappears. The conditions under which the paint is applied determine the drying time of the product and the properties of the paint film.
When carrying out touch-up painting, carry out a test painting of a small area. If an undesirable effect develops after drying, the old
If an undesirable effect is produced after drying, the old coating must be completely removed and the substrate prepared anew.

Store in tightly closed packaging.
Recommended ProGold tools: PremiumMix brush, FELT roller